当前位置首页 >> 新闻中心 >> 螺杆启闭机的安装步骤
螺杆启闭机的安装步骤
[来源:原创] [作者:aowl] [日期:18-05-03] [浏览次数:]
螺杆启闭机的安装步骤: The installation steps of the screw hoist: 1、在安装螺杆启闭机时一定要保持底座基础布置水平180º;启闭机底座与基础布置平面的接触面积要达到90%以上;螺杆轴线要垂直闸台上衡量的水平面;要与闸板吊耳孔文和垂直,避免螺杆倾斜,造成局部受力而损坏机件。 1, when installing the screw opening and closing machine, we must keep the base layout level of the base 180, and the contact area of the base and the base layout should reach more than 90%; the axis of the screw should be perpendicular to the horizontal surface of the sluice. 2、将手动螺杆启闭机置与安装位置,把一个限位盘套在螺杆上,将螺杆从横梁的下部旋入机器中,当螺杆从机器的上方露出后,再套上限位盘。螺杆的下方与闸门链接。 2, put the manual screw hoist and installation position, set a limit disk on the screw, screw the screw from the bottom of the beam into the machine, when the screw is exposed from the top of the machine, then the upper limit plate is set. The bottom of the screw is linked with the gate. 3、对于安装启闭机的基础必须稳固安全,机座和基础构件的混凝土,按图纸的规定浇筑,在混凝土强度未达到设计强度时,不准拆除和改变启闭机的临时支撑,更不得进行调试和试运转。 3, the foundation of the installation and closing machine must be stable and safe. The concrete of the machine base and the base component should be poured according to the stipulate of the drawing. When the strength of the concrete is not reached the strength of the design, it is not allowed to dismantle and change the temporary support of the hoist, and not to carry out the commissioning and trial operation. 4、在安装时根据闸门起吊中心线,找正中心使纵横向中心线偏差不超过正负3mm,高程偏差不超过正负5mm,然后浇注二期混凝土或与埋钢板链接。 4, in the installation of the center line according to the gate, find a positive center to the center line deviation not more than positive and negative 3mm, elevation deviation not more than positive and negative 5mm, and then cast two phases of concrete or linked with the buried steel plate. 5、对于产品的电气设备的安装,一定符合图纸及说明书的规定,全部电气设备均可靠的接地。 5, the installation of electrical equipment must conform to the requirements of drawings and instructions, and all electrical equipment is grounded reliably. 6、在产品安装完毕,要对机器进行处理,补修已损坏的保护油漆,灌注润滑。 6. After the product is installed, the machine should be processed, the damaged protective paint should be repaired, and the lubrication should be perfused.返首页:www.theblueissue.com
推一把28推百度